![]() ![]() The value for the convection coefficient can be modified using time or temperature curve while the value of the ambient temperature can be adjusted using a time curve. Radiation effects (heat transfer caused by electromagnetic waves) are defined using a surface boundary condition. The presence of radiation is accounted for by specifying an Ambient Temperature, Emissivity, and View Factor input. The value of the ambient temperature can be modified using a time curve, while the value of emissivity can be adjusted using a temperature curve. Thermal energy can be applied by specifying a Temperature, Heat Flux, or Heat Power boundary condition to model entities. The initial temperature option in the Temperature boundary condition is used to specify the initial temperature of entities when used in a Transient Thermal analysis. Heat flux can be applied to model surfaces. ![]() The value of heat flux can be modified by specifying a temperature or time curve. If the transient option is enabled in the Thermal study properties window, the thermostat option can be enabled and a model vertex can be selected. When the temperature of this vertex goes above the upper bound temperature, the heat flux turns off. When the temperature of this vertex goes below the lower bound temperature, the heat flux turns on. SOLIDWORKS FLOW SIMULATION FREE SURFACE PROFESSIONAL.SOLIDWORKS FLOW SIMULATION FREE SURFACE SOFTWARE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |